Tutorial How to Enable Diag Mode on Android Lollipop (Xiaomi redmi 3 / Pro)

Android Chip
Android Chip

Know Diag Mode on Android

YUKDIBACA.com -  Assalamu'alaikum , this time I'll give you a tutorial to enable DIAG MODE on Android Lolliop . Then what is it DIAG MODE? DIAG MODE Diagnostic mode or USB is a condition where we can configure NVRAM Android device to replace the radio band and android modem settings.
DIAG MODE usually used to unlock band GSM / WCDMA / LTE 4G android device. In order to activate the DIAG MODE, the device must be the root  first.
There are many ways to get in DIAG MODE. Each device has a different way depending on the manufacturer. Some devices can easily fit into DIAG MODE simply by typing a code on the dial pad . For example, by typing  * # * # 717 717 # * # *  on Xiaomi Xiaomi MI5 or redmi 1. However, some devices must use the terminals to enable this feature.
The Android version also affect this. Devices with version Kitkat, can be used to enter the DIAG terminal mode by typing  setprop sys.usb.config diag, adb  which is certainly in vogue  Super User . But sometimes this does not work on the Android version of  Lollipop . For that, this tutorial will explain how to get into the DIAG MODE for Android Lollipop especially on Xiaomi device redmi 3 / Pro.

Step Enabling Diagnostic Mode on Android

  1. Make sure  Bootloader  Xiaomi has been most unlock  the device can be root .
  2. The device has been most root  with  SuperSU .
  3. Download the MIUI Diag Mode Driver  and extract and install it. How to install them is by right-clicking all files with the extension * inf  and select install.
  4. Download adb driver  and install.
  5. Download adb and fastboot software  and extract.
  6. Enable Developer Mode and USB debugging on Xiaomi redmi 3 / Pro if it is not turned on (if it is already on, skip to step 7) by going to Settings -> About Phone -> touch MIUI Version 8 times until the notification You are now a developer " .
  7. Sign in to the Additional Settings and open the Developer options . Touch USB debugging to enable it.
  8. Furthermore, connect the device to the computer using a USB cable. Wait until the driver is installed (if not installed previously).
  9. Sign in adb folder and then open  CMD  by pressing  shift + right click -> select Open command window here
  10. To see if adb devices are connected or not, type  adb devices . If the device is connected, it appears the number of devices on cmd.
  11. Next type  adb shell  to open a command shell. No confirmation on the device to accept requests shell, select yes / OK.
  12. Type  SU  to be able to access the root .
  13. Upon entry to the  Super User  mode, this step is the difference with the android version of  Kitkat the type  setprop sys.usb.config diag, qdss, adb .Tutorial enable diag mode on android - YUKDIBACA.com
  14. If successful, the  port DIAG MODE will open and installed. Can be checked in device manager .Tutorial enable diag mode on android - YUKDIBACA.com
  15. After doing NVRAM settings, restart the device to apply the new settings.
Similarly, a few steps to enable DIAG MODE on Android Lollipop especially on Xiaomi device redmi 3 / Pro. Suggestions or if there is an additional, simply typed in the comment.

Note:
Always make it a habit to make backups before doing the experiment. Changing the value of NVRAM can cause havoc on your Android device. Damage caused to your device due to the personal mistakes is not our responsibility.

No comments:

Powered by Blogger.